Engine 2.2 parameter buttons not working

[Mart]

Hi there,

After updating to 2.2 on the Prime 2, I think the ‘parameter’ buttons (those on the right side of the pads) have stopped working. I used to use these to adjust loop length, but now I cannot use this anymore.

Please Denon will you fix this?

[Pasha]

You can use the rotary encoder to half/double the length of any running loop.

I think that denon may be about to use those parameter left/right arrows for something in particular soon.

[addie]

Also discussed over here

@addie

You can use the parameter buttons to increase or decrease the length of the loop in Auto Loop Mode. Pressing Loop pad while in Manual Loop Mode will enter Auto Loop Mode (the secundairy pad loop mode).