DocB
September 15, 2021, 2:01pm
1
So here is my setup: Prime 4, two SL-1200, Serato w/DVS expansion.
Since the Prime supports the DVS expansion how can I do the following:
Track A playing via DVS on one SL-1200
Track B playing on left hand Prime4 side
Track C playing on right hand Prime4 side
Track D playing via DVS on second SL-1200d
I am using the official Serato DVS vinyl.
The expansion is activated in Serato and I’ve calibrated the tables.
Here is a link to a picture of my setup: Denon Prime4 and Dual SL1200
Edit :
Yes, each table is set to phono input on the back.
Also each table is set to a different input via the front (USB, Thru) for testing and display.
Thanks for any help.
mufasa
September 15, 2021, 8:25pm
2
Are you looking to mix and match serato and engine (standalone) ?
It’s not possible.
Serato supports 4 decks, you should be able to run DVS on two channels and Int mode on the other 2 … but all serato
Mixlive
September 15, 2021, 9:10pm
3
What’s up @DocB ,
I can’t quite see it from your picture, but make sure that your DVS decks (3 & 4) are set for REL (relative) or ABS (absolute), not INT (internal). See the screen shot below:
Hope this helps. GOOD LUCK!
1 Like
DocB
September 15, 2021, 9:22pm
4
MixLive, you found my solution.
I switched them off INT and now my DVS (and I) are super happy.
I remember using those years (decades?) ago with my SL1.
3 Likes
Mixlive
September 15, 2021, 10:44pm
5
Glad to help. I still have my SL1…somewhere…
1 Like
system
Closed
September 16, 2021, 10:45pm
6
This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.