Hi there,
Is it possible that a cross fader or a line fader action (on a X1850) does not change the platter LEDs colour (on a SC5000M)? Is this default behavior adjustable?
Especially during scratching this is a bit strange.
Hope somebody can help.
Thanks, Christian
Hi @ronin1210
Go to the Utility menu (Press and hold View), and turn of On Air mode - that should do the trick
Best regards Engell
Thanks @Engell for the hint! That was the preference I was looking for.
Glad I could help
Ohh, and welcome to the forum
This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.