Was thinking the same. Already ordered.
I already owned the MC5, it’s a great device but since its passive, the sound was too quiet. Finally i bought a moukey mamx1 and power it using the usb-a connection from the back of the prime Go. Maybe some day I’ll post pics of my setup
I hope a lot of votes are not wasting away sitting on certain feature request that could of gone somewhere else.
So, today I tried to connect an aux in and also mic inputs to the Prime GO. Impossible to hear them using headphones, even if the cue mix position is in master out. But the big problem begin when I tried to record a set: no mic nor aux signals got recorded!! Isn’t any way to record aux in or mic on the Prime GO??
I think maybe you should read the thread.
@PKtheDJ, I already read the thread, and the conclusion, reading the thread is: NO, you can’t record aux or mic on the prime Go. But you are wrong, in a previous firmware I was able to record the mic and aux inputs.
Also, in this post these guys did it with the aux input:
Comment
byu/vernwozza from discussion
inDenonPrime
I mean this comment:
I actually used the AUX in on my Prime GO to record a set mixed on the SC6000/X1850 setup rather than running cables over to the computer. Worked pretty well and the sound quality seems fine, it’s a little disconcerting not having any overview on the channel routing for the AUX input on the Prime GO however.
EDIT: I just found this pdf https://cdn.inmusicbrands.com/denondj/EngineOS/16/Release%20Note%20History%20-%20Engine%20OS.pdf, where you can see that v1.5.1 enabled the feature to record the mic on the prime GO.
I’m wrong? To suggest you read the thread?
Anyway, it’s an old thread, and things change over time. Also the topics are slightly different. Originally it was discussing the ability to hear the mic and aux in the headphones (master signal), not to record or cue.
If v1.5.1 enabled mic recording then you have your answer - but that doesn’t necessarily mean it’s audible in the headphones (the original topic) or that the aux is included. If the functionality is there, you may need to enable it in the settings.