Hello everyone,
I have a rather simple question. On my Prime2, I was used to the Echo Out working like the Stutter Out. In other words, if I activate it, it also fades out.
On my new Prime4+, this only works on the Stutter Out? Does the Echo Out just stay at full volume? Or have I missed a setting? There are a few more settings than on the Prime2.
I’m familiar with the Echo fader, and it works as usual.
But that’s not what I’m talking about 
Best regards from lovely Germany
There are other settings on the FX, they work the same way as they do on the Prime 2 (middle knob controlling the parameters)
183 / 5.000
The parameters work, that’s not a problem. What I miss is that it automatically fades out when I activate it. It works with Stutter Out, but not Echo Out.
Do you not have to set a beat value for it? or adjust the amount of intensity? im not in front of my device at the minute but most effects have a coupe of additional parameters you can adjust that will impact the final sound.
Of course, I have it set to 1 beat. That works so far, except that it doesn’t fade out.
Hey @U-w-B - Can you try adding the wet/dry knob higher than 50%
0% - 50% will have the dry signal applied along side echo
50% - 100% should start to cut out the dry signal and echo all audio out when engaged.
Hmmm, i think someone who has a 4+ might need to chime in
Thats it!! Thanks 
I just used the buttons instead of paying attention to the bar above. 
This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.
