Denon MCX8000 riser stand

Hi I need to know if one of you have a diy riser stand for is controller in DVS mode. It’s to have a standard height (i think 3,5 inch) between the turntable.


Generally the hard flightcase lids should be able to do that for you - eg: the controller sits on the empty flightcase lid

The controller should be the correct height if it’s in a flight case, unless the 1200’s are in flight cases too. Then as DJ_Boothe said, put it on top of the lid. Before I had a flight case, I used an old piece of left over formica table top from the kitchen. It was a close enough height match.

Thanks for the tip of the formica and for the flight case use too.